1 Isolate all power before commencing installation. 

2 The road surface should be level and even ,any repair to the surface should be conducted prior to installation. 

3 Cut a channel between holes approximately 15mm wide to a depth of 60mm,ensure the channel is cleaned of all debris. 

4 Boring a specific size hole at the placement location of the road stud that should be Ø140mm*55mm. 

5 Use a blowtorch to dry any dampness from the holes,failure to do so may result in the adhesive glue not bonding correctly. 

6 Insert the protective rubber padding into the channel once it has been dried and had time to cool down. 

7 Pour the adhesive glue into the hole and locate the road stud so that its lighted side is facing towards to drivers. 

8 Inspect studs 2 hours after installation and re-adjust if there has any movement. 

9 Inspect after 4 hours and check that all studs are firmly located and show no signs of movement, if all have set correctly re-instate power